| STEP 1. |
If you haven't already done so, loosen the passenger side wheel lug nuts,
raise the front of the car, support it with jackstands and remove the wheel.
|
|
| STEP 2. |
Support the engine with a jack underneath the passenger side of the oil
pan. Make sure that it is secure. |
|
| STEP 3. |
Remove the plastic cap inside the wheel well for access to the motor mount
through bolt. |
Pic1
|
| STEP 4. |
Disconnect the evap canister purge solenoid and pull up on the solenoid so
you can tuck it out of the way. |
Pic2
|
| STEP 5. |
Slowly remove the mount through bolt. It's an 18mm. If it does not
come out straight you may need to make adjustments to the height of the jack holding the motor up. |
Pic3
|
| STEP 6. |
Remove the remaining two 15mm bolts holding the mount in place and then remove
the mount from the car. |
Pic4
|
| STEP 7. |
The insert goes into the mount as shown. It may be easier to install the
mount after getting it wet with a little water. Also a rubber mallet will help it go in. |
Pic5
Pic6
Pic7
|
| STEP 2. |
Reinstall the mount and slowly lower the jack holding the engine up.
Don't forget to hook the purge solenoid back up. |
|
