- How-To -
Rexified Motor Mount Installation Instructions
.
Remove the front motor mount from the car. Cut away the nub. This is how the mount looks after the nub is removed.
.
Locate your pieces and notice the letter designations A,B,C,D.
.
This is how the mount looks after the inserts are installed. Now put the motor mount back on the car.
  1. Remove the front motor mount from the car. 
  2. Use a coping saw or sharp utility knife to remove the rubber nub inside the motor mount.
  3. Holding the motor mount with spaces forming two “V”  shapes as shown in the picture, insert the larger of the two small pieces(labeled A) into the upper left section with the single cut side down, forming the “\” of the “V”.
  4. Next, insert the smallest piece(labeled B)into the upper right section with the flat side down, forming the “/” completing the smaller “V”. These pieces will not go in easily if not positioned correctly so check before forcing them in.
  5. Take the large piece labeled C and insert it into the lower left section of the motor mount with the grooved area facing inward and lined up with the pointed part in the middle of the  motor mount, forming the “\” of the “V”.
  6. Take the large piece labeled D and insert it into the lower right section of the motor mount with the grooved area facing inward and lined up with the pointed part in the middle of the motor mount forming the “/” of the “V”.
  7. Check to make sure these pieces are lined up correctly before pushing them all the way into the motor mount; then push them in.
  8. Reinstall the motor mount in your car.
.
If you have trouble shifting, make sure insert installation was done correctly.  Enjoy!

Note: There will be some increased noise and vibration.

Available from neoncars.com

These instructions are provided as a courtesy to Neon owners.  BANEON assumes no liability or warranty, express or implied, for the installation of the product via these instructions.